Black BLK-IPS103 Uživatelský manuál stáhnout pdf (Strana 10)

www.digiop.com

SECTION 2: INSTALLATION AND SETUP

Voltage type sensor wiring schematic

Relay type sensor wiring schematic

To connect a sensor to the camera, strip 1/4” of insulation from the sensor wires and insert them into the terminal block in the DI pin

locations shown above. The pin marked “C” in the terminal block is the common (COM) pin.

2.4.3 Alarm out (DO) connection

The camera supports one alarm out connection to relay type device. It provides up to 24 VAC @ 500 mA or 12 V DC @ 1 A. The

conguration of the relay type alarm wiring is illustrated in the diagram below.

CAUTION



Do not exceed the maximum relay rating. Refer to the specications in this manual for more information.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Žádné komentáře

Black BLK-IPS103 Uživatelský manuál Strana 10