Black BLK-IPE101 Uživatelský manuál stáhnout pdf (Strana 16)

www.sc-black.com

SECTION 2: INSTALLATION AND SETUP

2.7.4 RS-485 device connection

The encoder provides one RS-485 interface connection. The wiring signal polarity and ground to the

lower terminal block are shown in the schematic below.

RS-485 device wiring schematic

To connect an RS-485 device wiring to the encoder:

1. Route wiring from the RS-485 device interface to the encoder.

2. Strip 1/4” of insulation from DATA+, DATA-, and GND wires from the device and insert them into

the lower terminal block RS-485 D+, RS-485 D-, and RS-485 GND pins, respectively, as shown in

the schematic above.

2.7.5 RS-232C device connection

The RS-232C encoder interface can be connected to some devices, such as a Point of Sale (POS)

terminal. The wiring signal polarity and ground to the upper terminal block are shown in the schematic

below.

RS-232C device wiring schematic

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Žádné komentáře

Black BLK-IPE101 Uživatelský manuál Strana 16